How to make…Vintaj Leaf Charm & Swarovski Pearl Bracelet
[half]
1 To control the length of your stem, position the wire on the thick area of the pliers; now bend the wire away from you to make a right angle
[/half]
[half_last]
[/half_last]
[half]
2 Twist your wrist clockwise, move the wire to the thin area of the pliers and then bend the wire back on itself to form a half loop.
[/half]
[half_last]
[/half_last]
[half]
3 Again re-position the pliers by opening them and move you wrist anti-clockwise, then push the wire round to finish the loop.
[/half]
[half_last]
[/half_last]
[half]
4 Grip the pin at its end with round nose pliers and roll you wrist to make a complete turn. Now you can re-adjust the pin so that the loop sits directly on top of the stem.
[/half]
[half_last]
[/half_last]
[half]
5 Your loop is complete and ready to attach.
[/half]
[half_last]
[/half_last]
2 On 10 headpins place 1 x 4mm Swarovski, and make a wrapped loop on all 10 headpins.
3 Place on 3 headpins 1 x beadcap 1 x rhondell another beadcap and 1 x Czech faceted, make a wrapped loop on the 3 headpins, then on 2 other headpins repeat with the bead caps and rhondells without the Czech bead now make wrapped loops.
4 Place the leaves on the 6mm jump rings.
[half]
1 With your left hand hold the jump ring steady using one of the flat nose pliers. Now using another pair of flat nose pliers, with your right hand, bring them towards you to open.
[/half]
[half_last]
[/half_last]
[half]
2 To make sure you get a really secure fit, close the jump ring making sure that the ends touch each other.
[/half]
[half_last]
[/half_last]
5 Now you are ready to attach your beads onto the chain, cut the chain to your wrist size a little tighter than you need as you have the extension chain to make is bigger. Also remember to leave a couple of links free either side to attach the clasp on at the end, and if you need to adjust the length slightly. 6 Using the jump rings 6mm attach the Swarovski pearls along the bracelet, next attach the 2 x 4mm Swarovski to one jump ring and attach this next to the pearl, now add the rhondell with the Czech bead and next the leaf, repeat this pattern, alternate the rhondells with and without the Czech beads, leave a few links between each bead and leaves. 7 To finish attach the trigger clasp with the 7mm thick jump ring to one side at the end of the chain and the extension chain to other
You have now completed your charm bracelet…..
Well done!
Comments are closed here.