How to make…Antique Chain Beaded Necklace Kit

• 1x 6mm Vintage Gold pearl,
• 1x 10mm Emerald soft touch,
• 1x 6mm Vintage Gold pearl,
• 1x 6mm Vintage Gold

• 1x 4mm golden shadow,
• 1x 12mm Glass Discs Teal ,
• 1x 4mm golden shadow,

• 1x 6mm Vintage Gold pearl,
• 1x 8mm Antique Brass ,
• 1x 6mm Vintage Gold pearl,

• 1x 4mm Indian Sapphire,
• 1x 6mm Vintage Gold pearl,
• 1x 4mm Indian sapphire,

2 Attach each section in the order you made them, with a jump ring, making two lengths, Attach the flower connector, with a jump ring to the first eyepin you made, and repeat on the other side.

3 using another flower attach both sides to either side of the flower, leave a gap of two petals at the top and then attach to a petal either side, so it will hang evenly.

4 Place each of these set of beads in order shown on 1 headpin and make a loop.

[half]

• 1x 4mm Indian sapphire
• 1x Gold spacer,
• 1x 8mm pearl,
• 1x Gold spacer
• 1x 4mm Indian sapphire

• 1x 4mm golden shadow
• 1x Gold spacer,
• 1x 6mm pearl,
• 1x 4mm golden shadow

[/half] [half_last]

[/half_last]

Attach these onto a jump ring and then attach the jump ring to the bottom petal.

5 Place on a jump ring 2 feathers and attach this next to the headpin drops

6 Cut the chain in half, attach two sides to either side of a flower, this time leave 1 petal free at the top and the chain attaches either side of this. Hold the necklace around your neck and decide on the length, then cut the chain. Allow for 2.5cms as this will be the length of the clasp and jump rings.

7 Thread either side of the chain onto a jump ring, and attach to the Clasp.